Garage Door Opener Install

https://docs.google.com/presentation/d/1IglMwlvzJzA5S6ePZJcBh-0rtOnXw41Hl-RiOQfvbNk/edit#slide=id.g32e02103eca_0_0

Programming: [1]

Genie 7055 Garage Door Opener LED Status Codes

Source - [2]

System State	Opener Round LED (Blue)	Opener Long LED (Purple)	Sensor LEDs (Red / Green)	Meaning	Typical Action
Normal operation (fully programmed, ready)	Solid Blue	Off	Red solid / Green solid	System powered and operating normally	None required
Programming mode entered	Flashing Blue	Off	Red solid / Green solid	User pressed SET/PROGRAM to begin programming	Continue programming steps
Ready to program remote	Flashing Blue	Flashing Purple	Red solid / Green solid	Opener waiting for remote signal	Press remote button to pair
Travel limit programming mode	Blue on	Purple flashing	Red solid / Green solid	System waiting for UP/DOWN limits to be set	Set open and close positions
Door closing normally	Blue solid	Off	Red solid / Green solid	Normal closing operation	None
Door opening normally	Blue solid	Off	Red solid / Green solid	Normal opening operation	None
Safe-T-Beam blocked	Blue solid	Off	Red solid / Green flashing	Beam interrupted or object in doorway	Remove obstruction
Safe-T-Beam misaligned	Blue solid	Off	Red flashing / Green off or flashing	Sensors not aligned	Realign sensors
Safe-T-Beam wiring fault	Blue solid	Off	Red off / Green off	Sensor wiring disconnected or damaged	Inspect wiring to sensors
Door will not close unless wall button held	Blue solid	Off	Red flashing or Green flashing	Safety beam not detected	Fix sensor alignment or wiring
Power outage / battery backup mode	Blue may blink slowly or dim	Off	Red solid / Green solid	Opener running on battery backup	Restore AC power
System memory reset / no limits stored	Blue flashing	Purple flashing	Red solid / Green solid	Limits not programmed	Perform travel limit setup
Overcurrent / obstruction detected	Blue solid	Off	Red solid / Green solid	Door encountered resistance while moving	Check door tracks, springs, obstruction