User:Dorkmo/Log

10/2012

learned how to do laser printer transfer pcb etching

• made 2 detroit boards for texas
• updated wiki on process a little

going to design a sensor board to replace the reprap breakout board with allen from forum and perhaps william

• william and i came up with a board design to test out. hope to eliminate breakout completely

i have an appointment at the tulsa fab lab 10/13/2011

09/2012

prep for making some detroit boards + full documentation

• made two sets and sent back to fef
• started documenting process
• waiting on tulsa fab lab to open for business to cut two more boards for texas folks

slowly working on a personal prusa

• S. Korean stepper motors on back order

prep for making a Snap-Lock

• got a 24x48x1/2 hdpe sheet
• ordered a bit for shopbot to use when tulsa fab lab opens

prep for experimenting with solenoids

• spooled up a few for practice
• need to figure out power sourcing

light wiki editing

• did a little towards measurizing ceb model

08/2012

wired 4 ceb press control boxes (exluding arduinos)

assisted adam with clearing & roof

made some ceb sensor assemblies with cody