Lathe

Introduction

We are building a heavy duty lathe from scrach, based on the practical aspects of the Multimachine, and powered by LifeTrac

Specifications

Lathe_Specifications

Fabrication

• • Romig bed lathe type - from Multimachine -
  • Simple prototype, $486 in materials BOM:
    • 2 bearings, $50
    • 2 mouning plates, 1/2"x6" angle - $40
    • 4 Shaft Collars - $20
    • 2" shaft - $20
    • DOM tubing, 3", 2" ID - $15
    • 8 3/4" bolts for table - $16
    • Chuck plate - $40
    • Bolts for chuck - $20
    • Nuts and bolts for DOM - $5
    • XY table - $70 off shelf at Enco - [1]
    • Tool post - $10
    • table plate - $30
    • 2 bags of cement, 80 lb each - $20
    • sand, gravel - $10
    • TOTAL - $316
  • High performance, 2/1000" accuracy with proper technique, stock parts, 1000 lb radial and 200 lb axial load capacity

Links

• Light duty toy lathe - http://www.instructables.com/id/100-Homemade-Lathe/?ALLSTEPS