Cold Saw/V1 Design Files/Swivel Plate

Swivel Plate

• Length: 457.2mm

• Width: 304.8mm

• Thickness: 25.4mm

• Swivel Hole Diameter: 153mm

• Swivel Hole Spacing Along Length: 335mm

• Swivel Hole Spacing Along Width: 185mm

• Support Hole Diameter: 12mm with 20mm dia 13 deep countersink

• Support Hole Rectangle: 30mm x 55mm

• Support Hole Rectangle Spacing: At corner, 150mm apart center to center.

• Clamp Hole Diameter: 10.5mm dia, then M12x1.75 tapped

• Clamp Hole Spacing Along Width: 190mm (Swivel Hole Spacing Along Width)

• Clamp Hole Spacing Along Height: 12.7mm (Swivel Plate Thickness / 2)

• Support Hole Notes: The Support holes must be positioned such that the blade is centered at the vise. The blade should be centered at the vise so that angled cuts are facilitated in both directions (angling to both left and right). The Support holes should also leave enough space between the Shaft Blocks such that a thrust washer and clamping shaft collar can fit in between (and be easily maintained).

• 2D Image

• 3D CAD STP

File:ColdSawV1Swivelplate.stp

• 2D Fabrication Drawing PDF

File:ColdSawV1Swivelplate.pdf

• 2D Fabrication Drawing DXF

File:ColdSawV1Swivelplate.dxf