Cold Saw/V1 Design Files/Moving Block
< Cold Saw | V1 Design Files
Jump to navigation
Jump to search
Moving Block
- Length: 250mm
- Width: 76.2mm
- Height: 50.8mm
- Clamp Axis Centerline Height: 22mm
- Clamp Axis Hole Spacing: 95mm
- Width Notes: The width must be great enough so as to minimize the friction generated between the Moving Block and the Shafts under tension. If the width is too low, then the operator will not be able to clamp the workpiece with greater tension after a certain friction-caused stall point.
- Clamping Notes: The Clamp Blocks must be mounted to the Moving Blocks such that the Cold Saw accommodates angled cuts.
- 2D Image
- 3D CAD STP
- 2D Fabrication Drawing PDF
- 2D Fabrication Drawing DXF