All public logs

Combined display of all available logs of Open Source Ecology. You can narrow down the view by selecting a log type, the username (case-sensitive), or the affected page (also case-sensitive).

• 02:56, 20 June 2017 Marcin talk contribs uploaded a new version of File:D3DOriginal config.ini (Working version for production printing. Z offset is ~0, it doesn't appear to work. Z offset is set in hardware by single probing to determine 100 microns above print surface. PLA setting, 1.75mm, 205C nozzle and 60C bed.)
• 18:40, 10 June 2017 Marcin talk contribs uploaded a new version of File:D3DOriginal config.ini (OSE Lulzbot Cura settings with OSE Marlin: Max Z feed rate increased from 5 to 10 mm/s via M203 in Start GCode Travel speed reduced from 150 to 80 mm/s in Advanced Settings Infill speed reduced from 80 to 50 mms/s in Advanced Settings)
• 04:40, 10 June 2017 Marcin talk contribs uploaded a new version of File:D3DOriginal config.ini (Turns extruder heater and bed heater off.)
• 04:33, 10 June 2017 Marcin talk contribs uploaded a new version of File:D3DOriginal config.ini (Overrides Extruder Steps per mm setting of OSE Marlin with M92 E100 - or 100 extruder steps per mm of filament. This was measured using 1.75 mm PLA filament in D3D Original 16".)
• 22:18, 9 June 2017 Marcin talk contribs uploaded a new version of File:D3DOriginal config.ini (Added: set bed to standby temperature, and set extruder to 100C.)
• 21:17, 9 June 2017 Marcin talk contribs uploaded a new version of File:D3DOriginal config.ini (Set filament to 1.75mm and temperature to 205 for PLA. Bed is 60.)
• 21:07, 9 June 2017 Marcin talk contribs uploaded File:D3DOriginal config.ini