3D Printer Construction Set Workshop August 12, 2017
(Redirected from D3D Instructionals)
Contents
Language Agnostic Instructionals
See Development_Team_Log#Wed_Aug_9.2C_2017 for the Design Sprint.
Build Videos
Full Youtube Playlist of instructionals
Axis Motor Side
Carriage Axis
Idler Side
X Axis Assembly
Y Axis Assembly
Heated Bed Assembly
Frame Assembly
Extruder Assembly
Note that the extruder already comes assembled, so this is not an issue.
Final Assembly
Instructionals
Language Agnostic Instructionals
Short Idler Side of the Universal Axis
Extruder
[edit]
Overall Assembly
File:D3D Final Assembly SVGs-PNGs.zip
How to put color in Magnifying Bubbles
BOM
See August_12,_2017_Parts_Order
Final Quality Control Checklist
13" version
- Make sure all magnet attachments are reinforced solidly with superglue after all parts are adjusted in place.
- Make sure that the end of filament is not tied into the spool so it can come out of the spool instead of knocking the spool down. Best practice is to trim the tied end upon opening up a new spool so one doesn't forget
Heated Bed
- Make sure to attach PEI before the rods are attached to the heated bed, so that the middle of the PEI is attached firmly by putting a weight on the surface while it is being glued.
- Add a paper or other spacer on the underside of the heated bed plate to prevent the heated bed from drooping
