Basics

A Cordless Power Tool for inflating stuff/checking the pressure of Pneumatic Tires
Takes 20v Batteries, 12v Power (via an adapter) or wall power (via an UNINCLUDED adapter)
Can do Low Pressure, High Volume (For Pool Inflatables, Air Mattresses, or for Blowing Out HVAC Drain Lines etc), or High Pressure, Low Volume (For Tires, but also Soccer Balls/Basketballs etc

Review by User: Eric

So far so good
2ah Battery isn’t QUITE enough, but other than that it’s been great
Digital readout+auto stop is VERY nice
- Note that for anything above 50 PSI it starts getting a bit slow
- Absolute CHAMP for small flat tires/a “Maintenance refill” of a few PSI, but going from 30psi to 70 psi on a tire etc is a bit of a pain, and probably best left to a PROPER air compressor
- Uncertain on longevity of parts too if stressed like that
- Manual mentions don’t go over 100psig/it may have problems around there but who knows
  - Need a BOLTR style review+teardown
Also Air Pressure Metrology needs to be sorted out
Also uncertain on “cleanliness” of the compressed air, i THINK it is an Oil Free Air Compressor but who knows
Also a kit of adapters would be nice for car tires (to get into nooks etc)
I’ll list the case, but short of M/NP Pollution Concerns from the Foam, the Third Party Hard Case i got for it is VERY nice and makes it a good bit of VEDC Kit.

Ability to calibrate it
- Ie “here is 50psig from a NIST Traceable Source
- Uncertain if adding ambient temp+humidity sensor module could help with that too for “what is ambient right now”
- Also could help with Weather Based Tire Pressure Adjustments
  - IE “it is cold now, so if we max inflate it, when it is 90f next week we don’t want these to burst so lets not go TOO high” etc
The ability to deflate tires (rapidly) to a set value (ie can go up if low, and down if high, from the SV, as of now it can only add air
Easily Replaceable Hose
Option for running on USB-C PD
Pre-Filter for both pumps
Post-Filter and Dryer for the Compressed Air
Replaceable Anti-Vibration Feet
Also potentially a more “inherently balanced” pump?
Either tilted, tiltable, or dual screens so you don’t have to tilt the unit to read the values
It would add to bulk+complexity, but maybe have an “accessory tank” + conventional regulator assembly that is roughly the same dimensions. Not a TON of capacity, but could take the edge off the compressor (then be removed when not needed)
Thermal Sensors on Pump for Shutdown in the Event of Overheat (if this doesn’t already exist)
- Also could show pump temp on a screen
Depending on Oil Free Air Compressor life and/or how much Oil Ones can be miniaturized, that may be a nice variant for Lifetime Design reasons

All in all, especially if on sale, it’s a great buy that lets you easily “fix” low tires/toys and inflate air mattress and whatnot in a small form factor, using just about any type of power, and in not TOO bulky of a form factor
Short of potential improvements, or if it doesn’t last (in which case I’ll update this) it’s a great piece of kit