Deriving Power Electronics from Transistors and Microcontrollers

From Open Source Ecology
Jump to navigation Jump to search

Introduction

With the principle of Part Count Reduction within OSE's Module Based Design approach - we are interested in using this principle to facilitate the design of electronic circuits, and in particular, power electronic circuits.

With low cost microcontrollers (700 Mhz Pi Zero is $5) and transistors (IGBTs are $1/kW of power handling) - we can design low cost power electronics. Let's look at how this can be done for simple learning circuits which can serve as a basis of robust industrial applications. These examples show the limits of power for various devices.

Inverter

  • 10kW direct solar power inverter case using Arduino and IGBTs for $25. Inverter at 120V for regular loads such as power tools.
  • Start with 1kW of PV for test, then move to 10kW.
  • 10kW case is scalable to 100kW
  • Slide 12 of Open_Source_PV_System#Initial shows max power point - current at about 9A and voltage at 31V - for PV panels.

edit

1kW-10kW

  • 4 PV panels in series at 120VDC. 9A.
  • Arduino produces a square wave at 60 Hz at 50% duty cycle
  • Inversion occurs through an H bridge
  • Cost: [4] $4 for IGBTs (18kW continuous) [1]
  • Gate drivers - Arduino doesn't have enough juice to power IGBT gate efficiently - [4] $1 - [2]

10kW-100kW

  • Let's see cost of 54kW -
  • At 240V - need strings of 8 solar panels in series
  • Protection - 225 amp circuit breaker - $75[3]
  • 54kW for the above
  • Inversion - Just scale the IGBTs above. Use 3 instead of 1 for
  • For 54kW - switching and controller cost is $75 for DC source. Rest is safety and cooling.

Induction Furnace

Welder