Dirk 3D Printed Electric Motor Data Collection
- Did a 2-rotor, 1 stator version
- Went to 6 volts - current draw for 2-rotor (1 stator) version
- 12V at 2.5A. 200 hz frequency. 30W usage.
- 6 meters wound per coil
- Should be 12 wires of 3 meters - for more power draw.
- Didn't even get warm
- Was looking for optimal frequency - no feedback used.
- Would self-start by turning frequency dial on controller several times.
- It hummed when not started
