Extruder Troubleshooting
IF extruder is not feeding and it clicks:
- Get up to temperature and push filament through
- Examine if filament just oozes out - easy and uniform, thick as normal, rushes right down
- If that work then go to the extrude through Cura
- Get it up to temperature
- Do an extrusion through Cura
- If it works, then try extrusion through the LCD screen - do it under 1 mm move menu
- It takes about 30 minutes to clog up
- Check retraction settings - use 20/1 according to [1]
- Look into how print speed % changes retraction settings - does it change retraction again?
