LifeTrac v25/AI Prompts

Questions to ask and Discussions with AI

Dec 13, 2025

• lets change the design of the rear standing platform. lets use a piece of plate that spans next to the inner side wall and has a pivot point so that the platform can be folded up and down. perhaps some angle iron can attach to the plate coming off the pivot point, then the main platform can bridge accross to the other side's angle iron.

Dec 10, 2025

• • Lets create a new style of arms that utilitze cnc cut plates. Each arm will be feature two plates that have a curve down at the end so that they can attach to the bottom of the bucket attachment point. Perhaps 2x2 square tubing will be mounted between the plates as spacers.

Dec 9, 2025

• To build up structure
  • Need to add vertical plates along back end and mid point of machine between the sandwich walls. Lets use two matching angle irons with holes drilled in it to bolt a plate between the angle irons near the back of the machine between the two sides. the plate should be 1 inch from the the back end of the side plates. it should be perpendicular between the side plates. The back plate and angle iron should go to the top of the machine, but should avoid going all the way down so that it can avoid the wheel mounts and motors. a second plate and set of angle irons should be added at about the midpoint of the machine, but not too far forward where it will interfere with the arms' cross beam. the midpoint plate should go almost to the top of the side walls along the slated section, but perhaps leave an inch between the top of the side plates and the midpoint plate/angle irons. Also, avoid the bolts that hold the arms cylinders, mount below or to the side of room allows.
  • lets try to change the mounting style of the bucket attach point. lets put the end of the arm's pivot point at the top of the back of the bucket, and mount the bucket's hydraulic cylinders beneath the arms, attaching to the bottom of the arms and the bottom of the back of the bucket quick attach point. The attachment point of the cylinder and the pivot point of the arms will need to be moved on the back of the bucket attachment.