Sara Build Certification

Procedure

Build - [1]

Document on your log as Your_Name Build Certification with total of 18 pictures and 14 times.

1. Build frame. 3 detailed Finished Pictures showing the amount of epoxy used on inside bottom, inside sides, and inside top. Time.
2. Build Y Left Axis twice. Finished Picture from the side opposite of the motor. Time.
3. Build Y Right Axis twice. Finished Picture from the opposite side of the motor. Time.
4. Build X axis. Finished picture from motor side. Time
5. Build extruder assembly. Finished picture. Time.
6. Build heated bed (PEI addition + twist white wire around red. Finished picture from both sides. Time.
7. Build control panel. Finished picture from both sides. Time.
8. Mount Y axes and Z axes. Finished Picture. Time.
9. Mount the X axis. Finished picture. Time.
10. Mount heated bed. Finished picture. Time.
11. Mount extruder. Finished picture. Time.
12. Do cable chain and all wire routing and tidying. (Plugs should be labeled already). Finished picture. Time.
13. Mount spool holder and filament. Finished Picture. Time.
14. Upload .ini file for this printer to your log. Insert SD card with test cube. Print sample Test Cube at 50%. Picture closeup of cube. Time.

Links

• Sara Kit - [2]

Notes

• Label the frame in the kit build, but don't label motors
• Silver sharpie [3] for labeling during kit build. Label just cables for x, y, z cables, and x and y endstops