Truss Connector Plates
From Open Source Ecology
- Do they work on LP Smartside?
- Truss plates are pressed, not hammered, in the industry [1]. Extra nails can be used to increase strength. Nails are used in the insustry, typically to hold plates in place when pressing. True - try hammering without any holding, plate can move around.
- How to hammer one down properly. Lots of work - [2]
- Diy clamp with 3/4" bolts without hydraulic press [3]. A for design. B for efficiency.
Sourcing
- 2x3 inch for 49 cents [4]
- 1x4 - [5]
