LifeTrac 6 Parts Order: Difference between revisions
Jump to navigation
Jump to search
(→Order) |
|||
| Line 18: | Line 18: | ||
=Change Log= | =Change Log= | ||
*Change Log since [[6 in 60 Part Ordering]]: | *Change Log since [[6 in 60 Part Ordering]]: | ||
:*modified | :*Pivot plates were modified - rounded part was shortened | ||
:*All holes increased by 1/16" to 1-1/8" to facilitate bolting | :*All holes increased by 1/16" to 1-1/8" to facilitate bolting | ||
:*.dxf file showing the 30 holes on 4" centers that appear in a 10' 4x4 tube | :*.dxf file showing the 30 holes on 4" centers that appear in a 10' 4x4 tube | ||
:*The wheel mount plates are also modified per previous discussions, i.e. Holes for option of direct bolting to the 4x4s. | :*The wheel mount plates are also modified per previous discussions, i.e. Holes for option of direct bolting to the 4x4s. | ||
:*Re motor plate of the wheel The plates that the motor is bolted to were completely incorrect (MJ note: incorrect only if Motor Interface plate is not used, which it isn't) to accommodate the [[45.6 Cu In Motors]]. I made the corrections and made a new .dxf file (attached). | :*Re motor plate of the wheel The plates that the motor is bolted to were completely incorrect (MJ note: incorrect only if Motor Interface plate is not used, which it isn't) to accommodate the [[45.6 Cu In Motors]]. I made the corrections and made a new .dxf file (attached). | ||
Revision as of 00:45, 14 August 2013
Order
Using BOM Template:
quick attach wheel mount plates for the 1 7/8" shaft size
- [8]
- [8]
- [8]
- [8]
- [8]
- [8]
- [8]
Change Log
- Change Log since 6 in 60 Part Ordering:
- Pivot plates were modified - rounded part was shortened
- All holes increased by 1/16" to 1-1/8" to facilitate bolting
- .dxf file showing the 30 holes on 4" centers that appear in a 10' 4x4 tube
- The wheel mount plates are also modified per previous discussions, i.e. Holes for option of direct bolting to the 4x4s.
- Re motor plate of the wheel The plates that the motor is bolted to were completely incorrect (MJ note: incorrect only if Motor Interface plate is not used, which it isn't) to accommodate the 45.6 Cu In Motors. I made the corrections and made a new .dxf file (attached).