Revision as of 00:58, 14 August 2013

Order

Checklist:

First hole is 2 inches on center away from the edge, and all spacing is 4" between holes
All 4 sides of tubing are cut the same, so that holes are directly opposite from one another, and distance of the hole on each of the four sides is identical for each of the four sides

Pivot plates were modified - rounded part was shortened
All holes increased by 1/16" to 1-1/8" to facilitate bolting
.dxf file showing the 30 holes on 4" centers that appear in a 10' 4x4 tube
The wheel mount plates are also modified per previous discussions, i.e. Holes for option of direct bolting to the 4x4s.
Re motor plate of the wheel The plates that the motor is bolted to were completely incorrect (MJ note: incorrect only if Motor Interface plate is not used, which it isn't) to accommodate the 45.6 Cu In Motors. I made the corrections and made a new .dxf file (attached).

@@ Line 6: / Line 6: @@
 [https://docs.google.com/a/opensourceecology.org/spreadsheet/ccc?key=0ArpE5Y9PpJCXdE8ta3lldFhxQXJhTFViaVNhUFAxcXc#gid=0 edit]
+==Cloverdale Manufacturing Order Instructions==
+Checklist:
+*Flat plate is mild steel, 1/2" thick
+*Square tubing is 1/4"x4"x4" - in 10 foot lengths
+:*First hole is 2 inches on center away from the edge, and all spacing is 4" between holes
+:*All 4 sides of tubing are cut the same, so that holes are directly opposite from one another, and distance of the hole on each of the four sides is identical for each of the four sides
 =quick attach wheel mount plates for the 1 7/8" shaft size=