CO2 Laser: Difference between revisions
Jump to navigation
Jump to search
| Line 21: | Line 21: | ||
*Here's an Instructables laser cutter for thousands of dollars - [http://www.instructables.com/id/Zach-Radding-Homebrew-Laser-Cutter/] | *Here's an Instructables laser cutter for thousands of dollars - [http://www.instructables.com/id/Zach-Radding-Homebrew-Laser-Cutter/] | ||
*Not CO2, but still a homebrew laser engraver for $60, 1/4 watt - [http://www.instructables.com/id/S4B6L0OF2FRVB62/] | *Not CO2, but still a homebrew laser engraver for $60, 1/4 watt - [http://www.instructables.com/id/S4B6L0OF2FRVB62/] | ||
=Suppliers= | |||
*100W RF laser from [http://www.synrad.com/fseries/f100.htm Synrad] | |||
=Professional Consultants= | =Professional Consultants= | ||
Revision as of 18:59, 25 October 2009
Introduction
A low-cost laser cutter ($1-2k) can be made using laser engraver parts.
- The CO2 laser tube - $500 for 80 Watts
- Laser tube mount
- power supply
- focus lens - $65 at [1]
- lens mount
- reflection mirror
- mirror mount
Design Rationale
The enabling point of a practical, low-cost laser design is the ability to do significant cuts (1/8") by performing multiple passes over the cut pattern. If each cut does 10 thousandth of an inch in steel for an 80 watt laser - then 12 passes give you a 1/8" cut. This is sufficient, for example, to laser-cut a 20" Sawmill blade
Resources
- Understanding CO2 Lasers paper
- Excellent resources for homebrew lasers - http://planetstephanie.net/hi-tech-fun/lasers/
- Here's an Instructables laser cutter for thousands of dollars - [2]
- Not CO2, but still a homebrew laser engraver for $60, 1/4 watt - [3]
Suppliers
- 100W RF laser from Synrad
Professional Consultants
- Laser Kinetics
- Zach Radding, made a CO2 laser cutter featured in Instructables