Surplus Center CEB 6 Partial Order: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[Image:scceb6order.jpg]] | [[Image:scceb6order.jpg]] | ||
*Note- motor is 12 gpm continuous, so must be activated in parallel with other element or flow reduced | *Note- motor is 12 gpm (11.85) continuous, so must be activated in parallel with other element or flow reduced | ||
*motor is rated for 1800 psi | :*Advanced flow reduction strategy - running other components in parallel | ||
:*specific speeds and flows must be calibrated | |||
*motor is rated for 1800 psi (1840) so pressure reducer must be used | |||
*for 14 gpm - can use small cylinder motion to reduce flow, or just needle valve. | *for 14 gpm - can use small cylinder motion to reduce flow, or just needle valve. | ||
*for 28 gpm must have 3 solenoids going at once for shaker not to blow up | *for 28 gpm must have 3 solenoids going at once for shaker not to blow up | ||
*cushion valve must be used in all cases | *cushion valve must be used in all cases | ||
:*p spike upon startup is an issue - needs to be tested - data collection - ie - pressure spike upon startup | |||
*to test cushion valve, observe pressure with pressure valve in manual mode | *to test cushion valve, observe pressure with pressure valve in manual mode | ||
*next steps - use log splitter 2 stage pump for faster pressing | *next steps - use log splitter 2 stage pump for faster pressing | ||
*motor is 3.15 cu in/rev | |||
Latest revision as of 21:12, 28 April 2014
- Note- motor is 12 gpm (11.85) continuous, so must be activated in parallel with other element or flow reduced
- Advanced flow reduction strategy - running other components in parallel
- specific speeds and flows must be calibrated
- motor is rated for 1800 psi (1840) so pressure reducer must be used
- for 14 gpm - can use small cylinder motion to reduce flow, or just needle valve.
- for 28 gpm must have 3 solenoids going at once for shaker not to blow up
- cushion valve must be used in all cases
- p spike upon startup is an issue - needs to be tested - data collection - ie - pressure spike upon startup
- to test cushion valve, observe pressure with pressure valve in manual mode
- next steps - use log splitter 2 stage pump for faster pressing
- motor is 3.15 cu in/rev