Lasersaur Exterior Panel Installation: Difference between revisions
Jump to navigation
Jump to search
(Created page with "==Mon 2 Jun 2014== It's important to note that when installing the Lasersaur's exterior skin, the factory-drilled holes differ in distance from the edge of the aluminum plate ...") |
(No difference)
|
Revision as of 17:15, 3 June 2014
Mon 2 Jun 2014
It's important to note that when installing the Lasersaur's exterior skin, the factory-drilled holes differ in distance from the edge of the aluminum plate by about 1mm. This means that one side will be closer to the edge of the frame (or if installed upside down may protrude beyond the edge of the frame). So, make sure the panel is not upside down when installing to eliminate any misalignment of panels.
See the Lasersaur Manual online to see where the additional holes should be drilled on the panels and plastic door panels, or see Cris Log