The Liberator Full Release - Mechanical Fabrication: Difference between revisions
Jump to navigation
Jump to search
(→Frame) |
(→Frame) |
||
| Line 5: | Line 5: | ||
The Liberator Beta v2.0 is fabricated as follows. First, see the technical drawing for the overview: | The Liberator Beta v2.0 is fabricated as follows. First, see the technical drawing for the overview: | ||
[[Image:framedxf.jpg|thumb|Frame overview, see frame_overview.dxf (94.2 KB) from 01/20/2010 03:36 pm at [http://openpario.mime.oregonstate.edu/documents/94 Open+Pario] | [[Image:framedxf.jpg|thumb|Frame overview, see frame_overview.dxf (94.2 KB) from 01/20/2010 03:36 pm at [http://openpario.mime.oregonstate.edu/documents/94 Open+Pario] ]] | ||
The u-channels are shown around the cylinder and below the hopper. | |||
Here are some fabrication pictures: | |||
Revision as of 20:50, 31 May 2010
Frame
The frame consists of 7/16" thick, 6" wide u-channel. The frame is the same as that found in Prototype 1. You can use that as a fabrication guide. See the pictures 1-3 of CEB_Prototype_1_Fab.
The Liberator Beta v2.0 is fabricated as follows. First, see the technical drawing for the overview:
Frame overview, see frame_overview.dxf (94.2 KB) from 01/20/2010 03:36 pm at Open+Pario
The u-channels are shown around the cylinder and below the hopper.
Here are some fabrication pictures: