D3D Inventory: Difference between revisions
Jump to navigation
Jump to search
(Created page with "=Unpacking= It took 10 hours to unpack 12 printers: #Separate bolts by size #Separate every part by one of 10 Modules as at Prusa i3 Build Optimization") |
No edit summary |
||
| Line 1: | Line 1: | ||
=Unpacking= | =Unpacking= | ||
It took 10 hours to unpack 12 | It took 10 hours to unpack 12 [[Folgertech Prusa i3]] printer kits: | ||
#Separate bolts by size | #Separate bolts by size | ||
#Separate every part by one of 10 Modules as at [[Prusa i3 Build Optimization]] | #Separate every part by one of 10 Modules as at [[Prusa i3 Build Optimization]] | ||
=Further Prep= | |||
#Put set screws into L brackets (24 set screws per machine) | |||
#Separate aluminum beams and unwrap, then tape together into a bunch | |||
#Take bags off all aluminum bushing blocks | |||
#Put on jumpers onto controller boards | |||
#Put on stepper drivers onto controllers | |||
#Bend up the transistors on stepper drivers | |||
#Take backing off all plexiglas | |||
Revision as of 22:30, 17 March 2016
Unpacking
It took 10 hours to unpack 12 Folgertech Prusa i3 printer kits:
- Separate bolts by size
- Separate every part by one of 10 Modules as at Prusa i3 Build Optimization
Further Prep
- Put set screws into L brackets (24 set screws per machine)
- Separate aluminum beams and unwrap, then tape together into a bunch
- Take bags off all aluminum bushing blocks
- Put on jumpers onto controller boards
- Put on stepper drivers onto controllers
- Bend up the transistors on stepper drivers
- Take backing off all plexiglas