Prusa i3 Build Optimization: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 11: | Line 11: | ||
=Time Lapse of Extruder Slide Build= | =Time Lapse of Extruder Slide Build= | ||
<html><iframe width="420" height="315" src="https://www.youtube.com/embed/8NpA6lXc6FY" frameborder="0" allowfullscreen></iframe></html> | <html><iframe width="420" height="315" src="https://www.youtube.com/embed/8NpA6lXc6FY" frameborder="0" allowfullscreen></iframe></html> | ||
=Optimized Files= | |||
*3D printed bearing holder for bed - bearing have a hard time fitting - this one is increased by 1 mm in length so that bearings snap in readily - [[File:bedbushhold_upsize.stl]] | |||
=Links= | =Links= | ||
*[[XM Prusa i3 Procedure]] | *[[XM Prusa i3 Procedure]] | ||
Revision as of 01:34, 19 March 2016
Printer is broken down into modules for an optimized build, build times are shown,and quality control procedures + checklist are shown.
Time Lapse of Assembly
Time Lapse of Frame Build
Time Lapse of Extruder Slide Build
Optimized Files
- 3D printed bearing holder for bed - bearing have a hard time fitting - this one is increased by 1 mm in length so that bearings snap in readily - File:Bedbushhold upsize.stl