Talk:CEB Press Controller v16.10: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 13: | Line 13: | ||
*How do we want to connect the buttons and switches to the board? | *How do we want to connect the buttons and switches to the board? | ||
*Terminal headers? | *Terminal headers? | ||
*Jumper wire headers | |||
**Run 5V to panel switches and then run to MOSFET control | |||
**Need diode to prevent 5V going to into arduino? | |||
***Could relocate LED's | |||
***Do we need LEDs? Wont be able to see them. Only useful while trouble shooting. | |||
=Pressure Sensor= | =Pressure Sensor= | ||
Revision as of 03:47, 17 February 2017
Ethernet Jacks
- Looks like the ethernet jacks are about 0.601 inches wide.
- Fritzing defaults the distance between two jacks at 0.600.
- Might make a little extra room on the PCB design.
- Distance from hole mounts to bottom edge is 0.250
- Fritzing only has it as about 0.120
- Might move in from edge a little more
Switch Buttons
- How do we want to connect the buttons and switches to the board?
- Terminal headers?
- Jumper wire headers
- Run 5V to panel switches and then run to MOSFET control
- Need diode to prevent 5V going to into arduino?
- Could relocate LED's
- Do we need LEDs? Wont be able to see them. Only useful while trouble shooting.
Pressure Sensor
- What connections does the pressure sensor need?
- Power?