MicroTrac Controller v17.10/Code: Difference between revisions
Jump to navigation
Jump to search
(→Goals) |
(→Goals) |
||
| Line 3: | Line 3: | ||
*Transmit commands from the "remote controller" box to "onboard controller" box. | *Transmit commands from the "remote controller" box to "onboard controller" box. | ||
*Attempt to run identical arduino control software on both boxes. | *Attempt to run identical arduino control software on both boxes. | ||
**Will run in | **Will run in onboard mode if jumper set between defined pins. | ||
*Store radio information in EEPROM. Update on startup. | *Store radio information in EEPROM. Update on startup. | ||
**Create a program to define the EEPROM | **Create a program to define the EEPROM | ||
*Operate relay switches when "HAND" switch is on | *Operate relay switches when "HAND" switch is on | ||
Revision as of 01:13, 19 October 2017
Goals
- Establish serial communication over xbee radio
- Transmit commands from the "remote controller" box to "onboard controller" box.
- Attempt to run identical arduino control software on both boxes.
- Will run in onboard mode if jumper set between defined pins.
- Store radio information in EEPROM. Update on startup.
- Create a program to define the EEPROM
- Operate relay switches when "HAND" switch is on