D3D 1612 Product Manual: Difference between revisions
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
=Safety= | =Safety= | ||
=Operation= | =Operation= | ||
==Setting Bed Leveling Probing== | |||
*For D3D 1612 - set the following coordinates: | |||
[[File:d3d1612coords.jpg]] | |||
*Use 3 point probing in OSE Marlin. | |||
*To modify settings, go to Arduino IDE-> | |||
=Troubleshooting= | =Troubleshooting= | ||
*Heaters refversed in Cura. If you set the extruder temperature - and notice that the heatbed temperature is rising instead - then the order of the thermistors has been reversed. Move the extruder thermistor to the connector closer to the power plug on the RAMPS board. See Slide 4 of [[D3D_Controller#Wiring]] or the slide that has the thermistor wire detail. | *Heaters refversed in Cura. If you set the extruder temperature - and notice that the heatbed temperature is rising instead - then the order of the thermistors has been reversed. Move the extruder thermistor to the connector closer to the power plug on the RAMPS board. See Slide 4 of [[D3D_Controller#Wiring]] or the slide that has the thermistor wire detail. | ||
=Repair= | =Repair= | ||
Revision as of 23:26, 15 January 2018
Safety
Operation
Setting Bed Leveling Probing
- For D3D 1612 - set the following coordinates:
- Use 3 point probing in OSE Marlin.
- To modify settings, go to Arduino IDE->
Troubleshooting
- Heaters refversed in Cura. If you set the extruder temperature - and notice that the heatbed temperature is rising instead - then the order of the thermistors has been reversed. Move the extruder thermistor to the connector closer to the power plug on the RAMPS board. See Slide 4 of D3D_Controller#Wiring or the slide that has the thermistor wire detail.