Talk:CircularKnitic Parametric

adapting for variable needle size

ride height of needle

• the geared and non-geared plates sandwhich the butt of the needles to maintain control of the needles height
• before the needle is sent up it is breifly lowered slightly to pull tension on surrounding fabric.
• the lowest point of the groove on part CKp3.scad that the butt of the needle rides should be at this lowered position
• also the the length of the needle below the butt needs to have room to be lowered without hitting the top of the CKp3 base

• in general:
• the sandwich needs to be raised higher if the needle is longer below the butt
• the butt groove needs to be raised as well

• • the design could be changed to put holes in the base of CKp3 and the main table plate to allow the bottom of the needle to move freely downward
  • the butt groove would could start lower
  • could move all of CKp3's mounting screws outside of the circle.
  • use a style of claws similar to the inverse of CKp4 to hold up CKp1 from the base

bent tail

• some standard needles feature a design where the area section below the butt is bent up to meet the butt.
• this effectively doubles the "Y" dimension for the "B" dimension