Freezer to Refrigerator Conversion/Manufacturing Instructions: Difference between revisions
Jump to navigation
Jump to search
(Created page with "=Step by Step= ===1. drill holes=== *measure the diameter of the extension cord that will be used. *using a stepped drill bit, cut two holes on opposite sides of the box....") |
No edit summary |
||
| Line 1: | Line 1: | ||
=Step by Step= | ==Tool Check== | ||
*crimp tool | |||
*wire cutter | |||
*small blade screw driver | |||
*phillips screw driver | |||
<!--- insert picture of tools here ---> | |||
==Inventory Check== | |||
See [[Freezer_to_Refrigerator_Conversion#BOM|BOM]] | |||
<!--- insert picture of parts here ---> | |||
==Step by Step== | |||
Revision as of 05:15, 8 April 2018
Tool Check
- crimp tool
- wire cutter
- small blade screw driver
- phillips screw driver
Inventory Check
See BOM
Step by Step
1. drill holes
- measure the diameter of the extension cord that will be used.
- using a stepped drill bit, cut two holes on opposite sides of the box.
- the centered about 1"inch below edge of box
- drill a 5/32 hole for the thermister signal wire
2. place and cut wires
- cut extension cord for desired lengths. in half is fine.
- run about 8 inches of cord into holes.
- tie cord in a knot. pull knot firmly against the side of the box.
- strip off shielding, leaving about half an inch past knot.
3. fit check
- place the wall wart, relay switch and microcontroller into box.
- confirm that the usb cable can reach the microcontroller.
- using double sided stick strip, attach relay in place
4. crimp connections
- study the wiring harness diagram
- start with the extension cord wires.
- fit check the wires into place, then cut as needed.