Revision as of 23:11, 13 July 2018

Development Template

Do not plug the 3D printer into a wall outlet yet.

Verify power plug to power supply is ground, +, neutral/
Plug in RAMPS green plug to - + - + in that order from the left of green plug looking at the control panel.
Verify that the LCD is plugged in correctly - plug 1 and 2 as labeled
Plug in USB cable to computer
When USB cable is plugged in, LCD lights up daying OSE D3D Printer ready. This assumes the firmware is already on the controller board.

@@ Line 12: / Line 12: @@
 =Shakedown Checklist=
 ==Prior to Turn-On==
-*Verify that the LCD is plugged in correctly - plug 1 and 2
+<html><iframe src="https://www.facebook.com/plugins/post.php?href=https%3A%2F%2Fwww.facebook.com%2Fmarcin.jakubowski.378%2Fposts%2F10214039313274046&width=500" width="500" height="377" style="border:none;overflow:hidden" scrolling="no" frameborder="0" allowTransparency="true" allow="encrypted-media"></iframe></html>
+'''Do not plug the 3D printer into a wall outlet yet.'''
+#Verify power plug to power supply is ground, +, neutral/
+#Plug in RAMPS green plug to - + - + in that order from the left of green plug looking at the control panel.
+#Verify that the LCD is plugged in correctly - plug 1 and 2 as labeled
+#Plug in USB cable to computer
+#When USB cable is plugged in, LCD lights up daying '''OSE D3D Printer ready'''. This assumes the firmware is already on the controller board.
 *Plug in
-*Verify power plug to power supply is ground, +, neutral
-*Verify polarity of main power, stepper power
 *Verify axis motion
 *Verify all printing parameters - [[G_Codes#Status_Codes]]
 *Make sure print profile (.ini file) is correct)