D3D v18.07: Difference between revisions
Jump to navigation
Jump to search
| Line 16: | Line 16: | ||
<html><iframe src="https://www.facebook.com/plugins/post.php?href=https%3A%2F%2Fwww.facebook.com%2Fmarcin.jakubowski.378%2Fposts%2F10214039313274046&width=500" width="500" height="377" style="border:none;overflow:hidden" scrolling="no" frameborder="0" allowTransparency="true" allow="encrypted-media"></iframe></html> | <html><iframe src="https://www.facebook.com/plugins/post.php?href=https%3A%2F%2Fwww.facebook.com%2Fmarcin.jakubowski.378%2Fposts%2F10214039313274046&width=500" width="500" height="377" style="border:none;overflow:hidden" scrolling="no" frameborder="0" allowTransparency="true" allow="encrypted-media"></iframe></html> | ||
'''Do not plug the 3D printer into a wall outlet yet.''' | #'''Do not plug the 3D printer into a wall outlet yet.''' Verify power plug to power supply is Line, Neutral, Ground - in that order. The ground is the green wire. Either polarity of the L and N wires will work, but the correct convention is white wire for Line and black wire for Neutral. | ||
#Plug in RAMPS green plug to - + - + in that order from the left of green plug looking at the control panel. | #Plug in RAMPS green plug to - + - + in that order from the left of green plug looking at the control panel. | ||
#Verify that the LCD is plugged in correctly - plug 1 and 2 as labeled | #Verify that the LCD is plugged in correctly - plug 1 and 2 as labeled | ||
Revision as of 23:14, 13 July 2018
Development Template
Build
Extruder Build
Shakedown Checklist
Prior to Turn-On
- Do not plug the 3D printer into a wall outlet yet. Verify power plug to power supply is Line, Neutral, Ground - in that order. The ground is the green wire. Either polarity of the L and N wires will work, but the correct convention is white wire for Line and black wire for Neutral.
- Plug in RAMPS green plug to - + - + in that order from the left of green plug looking at the control panel.
- Verify that the LCD is plugged in correctly - plug 1 and 2 as labeled
- Plug in USB cable to computer
- When USB cable is plugged in, LCD lights up daying OSE D3D Printer ready. This assumes the firmware is already on the controller board.
- Plug in
- Verify axis motion
- Verify all printing parameters - G_Codes#Status_Codes
- Make sure print profile (.ini file) is correct)