D3D v18.07: Difference between revisions
Jump to navigation
Jump to search
| Line 20: | Line 20: | ||
#Verify that the LCD is plugged in correctly - plug 1 and 2 as labeled | #Verify that the LCD is plugged in correctly - plug 1 and 2 as labeled | ||
#Plug in USB cable to computer | #Plug in USB cable to computer | ||
#When USB cable is plugged in, LCD lights up | #When USB cable is plugged in, LCD lights up saying '''OSE D3D Printer ready'''. This assumes the firmware is already on the controller board. | ||
#Check the thermistor on the extruder. Plugging it into the control board should produce the temperature. Unplugged shows zero temperature, and shorted shows max temperature. | |||
# | |||
*Plug in | *Plug in | ||
Revision as of 23:29, 13 July 2018
Development Template
Build
Extruder Build
Shakedown Checklist
Prior to Turn-On
- Do not plug the 3D printer into a wall outlet yet. Verify power plug to power supply is Line, Neutral, Ground - in that order. The ground is the green wire. Either polarity of the L and N wires will work, but the correct convention is white wire for Line and black wire for Neutral.
- Plug in RAMPS green plug to - + - + in that order from the left of green plug looking at the control panel.
- Verify that the LCD is plugged in correctly - plug 1 and 2 as labeled
- Plug in USB cable to computer
- When USB cable is plugged in, LCD lights up saying OSE D3D Printer ready. This assumes the firmware is already on the controller board.
- Check the thermistor on the extruder. Plugging it into the control board should produce the temperature. Unplugged shows zero temperature, and shorted shows max temperature.
- Plug in
- Verify axis motion
- Verify all printing parameters - G_Codes#Status_Codes
- Make sure print profile (.ini file) is correct)