Microfactory Boot Camp - Extruder Build: Difference between revisions
Jump to navigation
Jump to search
(→Notes) |
(→Notes) |
||
| Line 4: | Line 4: | ||
*20:22 in the video - Collet Clip - see E3D Instructions regarding the Collet Clip. Note that because the filament hole in the extruder 3D printed piece is elongated - and the collet clip is elongated - the collet clip should sit in this hole in a way that allows the collet clip to line up with the hole. | *20:22 in the video - Collet Clip - see E3D Instructions regarding the Collet Clip. Note that because the filament hole in the extruder 3D printed piece is elongated - and the collet clip is elongated - the collet clip should sit in this hole in a way that allows the collet clip to line up with the hole. | ||
*24:50 - location of drive gear | *24:50 - location of drive gear | ||
*26:29 - placing cover on top of the extruder | |||
Revision as of 13:37, 7 September 2018
Notes
- 20:22 in the video - Collet Clip - see E3D Instructions regarding the Collet Clip. Note that because the filament hole in the extruder 3D printed piece is elongated - and the collet clip is elongated - the collet clip should sit in this hole in a way that allows the collet clip to line up with the hole.
- 24:50 - location of drive gear
- 26:29 - placing cover on top of the extruder