Extruder Troubleshooting: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 9: | Line 9: | ||
#It takes about 30 minutes to clog up | #It takes about 30 minutes to clog up | ||
#Check retraction settings - use 20/1 according to [https://www.sublimelayers.com/2016/10/some-musings-on-retracts.html?m=1] | #Check retraction settings - use 20/1 according to [https://www.sublimelayers.com/2016/10/some-musings-on-retracts.html?m=1] | ||
#Look into how print speed % changes retraction settings - does it change retraction again? | |||
Latest revision as of 16:57, 1 November 2018
IF extruder is not feeding and it clicks:
- Get up to temperature and push filament through
- Examine if filament just oozes out - easy and uniform, thick as normal, rushes right down
- If that work then go to the extrude through Cura
- Get it up to temperature
- Do an extrusion through Cura
- If it works, then try extrusion through the LCD screen - do it under 1 mm move menu
- It takes about 30 minutes to clog up
- Check retraction settings - use 20/1 according to [1]
- Look into how print speed % changes retraction settings - does it change retraction again?