3D Printer Stops Midprint: Difference between revisions
Jump to navigation
Jump to search
(Created page with "*Typically this is a slicer error where spurious results happen from slicing - reslice and try again. Just moving the object on the bed may help. *m600 m410 m125 m0 or many of...") |
No edit summary |
||
| Line 1: | Line 1: | ||
*Typically this is a slicer error where spurious results happen from slicing - reslice and try again. Just moving the object on the bed may help. | *Typically this is a slicer error where spurious results happen from slicing - reslice and try again. Just moving the object on the bed may help. | ||
*m600 m410 m125 m0 or many of the other commands that could be triggering the same or similar pause states. - see [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/] | *m600 m410 m125 m0 or many of the other commands that could be triggering the same or similar pause states. - see [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/] | ||
*Might be bad SD card - [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/] | |||
*Reinstalling Cura helped - [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/] | |||
Revision as of 23:29, 20 July 2019
- Typically this is a slicer error where spurious results happen from slicing - reslice and try again. Just moving the object on the bed may help.
- m600 m410 m125 m0 or many of the other commands that could be triggering the same or similar pause states. - see [1]
- Might be bad SD card - [2]
- Reinstalling Cura helped - [3]