3D Printer Stops Midprint: Difference between revisions

Revision as of 23:32, 20 July 2019

Typically this is a slicer error where spurious results happen from slicing - reslice and try again. Just moving the object on the bed may help.
Thermal cutout on extruder motor - last issue at [1]
Obvious ones - filament ran out, broke, or stripped - [2]
m600 m410 m125 m0 or many of the other commands that could be triggering the same or similar pause states. - see [3]
Might be bad SD card - [4]
Reinstalling Cura helped - [5]

@@ Line 1: / Line 1: @@
 *Typically this is a slicer error where spurious results happen from slicing - reslice and try again. Just moving the object on the bed may help.
+*Thermal cutout on extruder motor - last issue at [http://www.geeetech.com/blog/2018/01/troubleshooting-does-your-3d-printer-stop-in-the-middle-of-a-print-we-have-the-solution/]
+*Obvious ones - filament ran out, broke, or stripped - [http://www.geeetech.com/blog/2018/01/troubleshooting-does-your-3d-printer-stop-in-the-middle-of-a-print-we-have-the-solution/]
 *m600 m410 m125 m0 or many of the other commands that could be triggering the same or similar pause states. - see [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/]
 *Might be bad SD card - [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/]
 *Reinstalling Cura helped - [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/]