3D Printer Stops Midprint: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
*Typically this is a slicer error where spurious results happen from slicing - reslice and try again. Just moving the object on the bed may help. | *Typically this is a slicer error where spurious results happen from slicing - reslice and try again. Just moving the object on the bed may help. | ||
*Thermal cutout on extruder motor - last issue at [http://www.geeetech.com/blog/2018/01/troubleshooting-does-your-3d-printer-stop-in-the-middle-of-a-print-we-have-the-solution/] | *Thermal cutout on extruder motor - last issue at [http://www.geeetech.com/blog/2018/01/troubleshooting-does-your-3d-printer-stop-in-the-middle-of-a-print-we-have-the-solution/]. Yes, A4998 do have thermal shutdown - [https://www.pololu.com/product/1182] - so reduce the current on your stepper driver. Currently doing 0.3V on 24V RAMPS. | ||
*Obvious ones - filament ran out, broke, or stripped - [http://www.geeetech.com/blog/2018/01/troubleshooting-does-your-3d-printer-stop-in-the-middle-of-a-print-we-have-the-solution/] | *Obvious ones - filament ran out, broke, or stripped - [http://www.geeetech.com/blog/2018/01/troubleshooting-does-your-3d-printer-stop-in-the-middle-of-a-print-we-have-the-solution/] | ||
*m600 m410 m125 m0 or many of the other commands that could be triggering the same or similar pause states. - see [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/] | *m600 m410 m125 m0 or many of the other commands that could be triggering the same or similar pause states. - see [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/] | ||
Latest revision as of 23:39, 20 July 2019
- Typically this is a slicer error where spurious results happen from slicing - reslice and try again. Just moving the object on the bed may help.
- Thermal cutout on extruder motor - last issue at [1]. Yes, A4998 do have thermal shutdown - [2] - so reduce the current on your stepper driver. Currently doing 0.3V on 24V RAMPS.
- Obvious ones - filament ran out, broke, or stripped - [3]
- m600 m410 m125 m0 or many of the other commands that could be triggering the same or similar pause states. - see [4]
- Might be bad SD card - [5]
- Reinstalling Cura helped - [6]
- New Cura has bugs - [7]