Turbine Optimization: Difference between revisions
Jump to navigation
Jump to search
(Added some more information) |
(Added some more information) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
=Basics= | =Basics= | ||
*This page goes over how you go from "generic turbine" to each speciality | *This page goes over how you go from "generic turbine" to each speciality, each with "optima" efficency | ||
=Turbojet= | =Turbojet= | ||
| Line 18: | Line 18: | ||
==Papers on the Subject== | ==Papers on the Subject== | ||
*[[https://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/20190002272.pdf A Nasa Paper on Designing an Airplane Turboshaft]] (may be more mass focused) | *[[https://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/20190002272.pdf A Nasa Paper on Designing an Airplane Turboshaft]] (may be more mass focused) ( '''Needs looking into by someone who knows what they are doing''' ) | ||
*[https://aip.scitation.org/doi/pdf/10.1063/1.5138794 "A Scalable Model for Design and Control of Turboprop Engines for Advanced Propulsion Systems" ] ( '''Needs looking into by someone who knows what they are doing''' ) | |||
=Steam Turbine= | =Steam Turbine= | ||
Latest revision as of 16:01, 5 April 2020
Basics
- This page goes over how you go from "generic turbine" to each speciality, each with "optima" efficency
Turbojet
- Optimise for thrust, mass, and size
Turbofan
- Same as turbojet, but extra compression and/or air diversion
Turboprop and/or Turboshaft
- This will be the main OSE investigation due to the lack of size and/or mass constraints
- Will be used as a Turbogenerator and/or in the Universal Burn Unit
- Optimize for power extracted
- Either by:
- Direct attach shaft
- "Free Shaft" (Similar to an exhaust turbocharger)
Papers on the Subject
- [A Nasa Paper on Designing an Airplane Turboshaft] (may be more mass focused) ( Needs looking into by someone who knows what they are doing )
- "A Scalable Model for Design and Control of Turboprop Engines for Advanced Propulsion Systems" ( Needs looking into by someone who knows what they are doing )
Steam Turbine
Liquid Turbine
Tesla Turbine
Methods
- OpenFOAM
- Turbine Design Software
- AI Design
- Engineer SMEs in a relevant field
Workflow
Phase 1
- Build simple hobby/lab scale device
Phase 2
- Tinker with and modify phase 1 for improvements + learning as you go along
Phase 3
- Dedicated engineer, software, and perhaps AI Design of blade geometry etc
- This is where the real "optimal efficiency" is obtained