D3D v20.04.27 Repair Guide: Difference between revisions
Jump to navigation
Jump to search
(Created page with " =Links= *D3D v20.04.27") |
No edit summary |
||
| Line 1: | Line 1: | ||
=Replacing Bearings in Y Carriage= | |||
#Disconnect plug from X axis motor and end stop | |||
#Remove 3 m3x25 screws on the underside of the X axis motor. (note that this is not necessary if the nuts are in the nut catchers under the stepper motor - in that case only the M6 bolts in the next step need to be loosened to take off the motor. | |||
#Remove stepper motor to the side | |||
#Loosen the M6 screws on the motor side and the idler side to remove the X axis from the Y axes. Straddle the X axis on top of the printer. | |||
#Disconnect the plugs from the 2 Y axis stepper motors and one single Y endstop | |||
#Remove the Y axes | |||
#Release the belt by removing belt peg. | |||
#Remove the idler sides from Y Axes | |||
#Remove the carriages | |||
#'''Open carriges up and replace bearings.''' | |||
# | |||
=Links= | =Links= | ||
*[[D3D v20.04.27]] | *[[D3D v20.04.27]] | ||
Revision as of 21:37, 29 April 2020
Replacing Bearings in Y Carriage
- Disconnect plug from X axis motor and end stop
- Remove 3 m3x25 screws on the underside of the X axis motor. (note that this is not necessary if the nuts are in the nut catchers under the stepper motor - in that case only the M6 bolts in the next step need to be loosened to take off the motor.
- Remove stepper motor to the side
- Loosen the M6 screws on the motor side and the idler side to remove the X axis from the Y axes. Straddle the X axis on top of the printer.
- Disconnect the plugs from the 2 Y axis stepper motors and one single Y endstop
- Remove the Y axes
- Release the belt by removing belt peg.
- Remove the idler sides from Y Axes
- Remove the carriages
- Open carriges up and replace bearings.