OpenSCAD Flighting Generator: Difference between revisions
(Created page with "File:flightinggen.scad File:augerflights.png Parameters used above: //The total amount of twist, in degrees Auger_twist = '''300'''; //[90:1080] //The radius of t...") |
No edit summary |
||
| Line 1: | Line 1: | ||
[[File:flightinggen.scad]] | [[File:flightinggen.scad.zip]] | ||
[[File:augerflights.png]] | [[File:augerflights.png]] | ||
Revision as of 16:29, 18 September 2020
Parameters used above:
//The total amount of twist, in degrees Auger_twist = 300; //[90:1080]
//The radius of the auger's "flight" past the shaft Auger_flight_radius = 20; //[5:50]
//The number of "flights" Auger_num_flights = 1; //[1:5]
//The height, from top to bottom of the "shaft" Auger_flight_length = 10; //[10:200]
/* [Printer] */ //The overhang angle your printer is capable of Printer_overhang_capability = 0; //[0:40]
//The thickness of perimeter support material Auger_perimeter_thickness = 0.0; //[0:None, 0.8:Thin, 2:Thick]
//The radius of the auger's "shaft" Auger_shaft_radius = 5; //[1:25]
//The thickness of the "flight" (in the direction of height) Auger_flight_thickness = 1; //[0.2:Thin, 1:Medium, 10:Thick] Auger_handedness = "right"; //["right":Right, "left":Left]