How to Print With Acetal: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
=Hacked= | |||
https://www.thingiverse.com/groups/engineering/forums/general/topic:11262 | https://www.thingiverse.com/groups/engineering/forums/general/topic:11262 | ||
Summary: bed 160C, near melt point. Nozzle 230C. | Summary: bed 160C, near melt point. Nozzle 230C. | ||
=OSE Case= | |||
OSE's PEI surface is rated for 168C - [https://www.mcmaster.com/8685K42]. So this is a perfect test case of the OSE [[D3D Pro]] insulated heated bed. Because the bed is insulated, the temperature variation should also be lower. (data to be obtained) | |||
=More about printing= | |||
*Using lame equipment - [https://all3dp.com/2/pom-acetal-delrin-3d-printing/] | |||
=Sourcing= | |||
*See [[POM]] | |||
=Links= | =Links= | ||
*[[Acetal Filament]] | *[[Acetal Filament]] | ||
*[[POM]] | *[[POM]] | ||
Latest revision as of 02:47, 25 June 2021
Hacked
https://www.thingiverse.com/groups/engineering/forums/general/topic:11262
Summary: bed 160C, near melt point. Nozzle 230C.
OSE Case
OSE's PEI surface is rated for 168C - [1]. So this is a perfect test case of the OSE D3D Pro insulated heated bed. Because the bed is insulated, the temperature variation should also be lower. (data to be obtained)
More about printing
- Using lame equipment - [2]
Sourcing
- See POM