Senville Aura: Difference between revisions
Jump to navigation
Jump to search
| Line 27: | Line 27: | ||
=Mounting Bracket= | =Mounting Bracket= | ||
*$70 - [https://www.sylvane.com/senville-wall-mounting-bracket-ha-550.html] | *$70 - [https://www.sylvane.com/senville-wall-mounting-bracket-ha-550.html] | ||
=Troubleshooting= | |||
*Vacuum doesn't draw down - [https://www.youtube.com/watch?v=JUM67dplsfU] | |||
Revision as of 04:56, 30 December 2021
Installation
Key Videos
- Point - disconnect vacuum After filling up low pressure side with 1 PSI of refrigerant- [1]
- 1 lb? Not 1 atm? Under 1 lb, 14 psi of atmosphere would mean that air actaully leaks into the tubing.
- Note that instructions say to 'let in refrigerant for 5 seconds with quarter turn of valve' - steps 9-10 on page 30 of manual [2]. This is not correct - we should look at the actual valve, no? Video says 1 lb - also not correct. The right way should be to look at the valve, not by time - but by when valve reads a little above atmospheric pressure of 14 psi.
Manual
R-410A - Refrigerant
- https://www.rses.org/assets/r410a/R-410A.PDF
- Pressure-Temperature chart is shown at end of PDF above
Build Pictures
Specs
Heat pump for heating and cooling that works down to -20F. 7kW of heat.
Mounting Bracket
- $70 - [4]
Troubleshooting
- Vacuum doesn't draw down - [5]