3D Printer Firmware Comparison: Difference between revisions
Jump to navigation
Jump to search
(Added some more information) |
(Added some more links under the "Internal Links" section) |
||
| Line 22: | Line 22: | ||
=Internal Links= | =Internal Links= | ||
* | *[[Klipper]] | ||
*[[OSE Marlin]] | |||
*[[Octoprint]] | |||
=External Links= | =External Links= | ||
*[https://all3dp.com/2/3d-printer-firmware-which-to-choose-and-how-to-change-it/ An Article by "[[All3DP]]" Titled "3D Printer Firmware: Best Options of 2021" ] | *[https://all3dp.com/2/3d-printer-firmware-which-to-choose-and-how-to-change-it/ An Article by "[[All3DP]]" Titled "3D Printer Firmware: Best Options of 2021" ] | ||
*[https://all3dp.com/2/klipper-vs-marlin-difference/ An Article by "[[All3DP]]" Titled "Klipper vs Marlin: The Differences" ] | *[https://all3dp.com/2/klipper-vs-marlin-difference/ An Article by "[[All3DP]]" Titled "Klipper vs Marlin: The Differences" ] | ||
Revision as of 00:13, 23 January 2022
Basics
- This page aims to provide a basic summary, and comparison of, the various Firmware Options for 3D Printers
Open Source
Klipper
- Can be run with a Raspberry Pi Zero and a standard (8 bit? ) Control Board
Marlin
Marlin Forks
- OSE Marlin (Duh!)
- Prusa Marlin
RepRap Firmware
- Typically run on Duet3D Control Boards
Misc.
- This is for Open Source, yet quite limited / not common firmware options:
Internal Links
External Links
- An Article by "All3DP" Titled "3D Printer Firmware: Best Options of 2021"
- An Article by "All3DP" Titled "Klipper vs Marlin: The Differences"