3D Printer Firmware Comparison: Difference between revisions
Jump to navigation
Jump to search
(Added some more links under the "External Links" section) |
(Added a Category to the Page) |
||
| (4 intermediate revisions by the same user not shown) | |||
| Line 3: | Line 3: | ||
=Open Source= | =Open Source= | ||
==Klipper== | ==[[Klipper]]== | ||
* | *Can be run with a [[Raspberry Pi Zero]] and a standard (8 bit? ) [[Control Board]] | ||
== [[Marlin]] == | == [[Marlin]] == | ||
| Line 14: | Line 14: | ||
== [[RepRap Firmware]] == | == [[RepRap Firmware]] == | ||
* | *Typically run on [[Duet3D]] Control Boards | ||
== Misc. == | == Misc. == | ||
| Line 22: | Line 22: | ||
=Internal Links= | =Internal Links= | ||
* | *[[Klipper]] | ||
*[[OSE Marlin]] | |||
*[[Octoprint]] | |||
=External Links= | =External Links= | ||
*[https://all3dp.com/2/3d-printer-firmware-which-to-choose-and-how-to-change-it/ An Article by "[[All3DP]]" Titled "3D Printer Firmware: Best Options of 2021" ] | *[https://all3dp.com/2/3d-printer-firmware-which-to-choose-and-how-to-change-it/ An Article by "[[All3DP]]" Titled "3D Printer Firmware: Best Options of 2021" ] | ||
*[https://all3dp.com/2/klipper-vs-marlin-difference/ An Article by "[[All3DP]]" Titled "Klipper vs Marlin: The Differences" ] | |||
[[Category: 3D Printing]] | |||
Latest revision as of 00:14, 23 January 2022
Basics
- This page aims to provide a basic summary, and comparison of, the various Firmware Options for 3D Printers
Open Source
Klipper
- Can be run with a Raspberry Pi Zero and a standard (8 bit? ) Control Board
Marlin
Marlin Forks
- OSE Marlin (Duh!)
- Prusa Marlin
RepRap Firmware
- Typically run on Duet3D Control Boards
Misc.
- This is for Open Source, yet quite limited / not common firmware options:
Internal Links
External Links
- An Article by "All3DP" Titled "3D Printer Firmware: Best Options of 2021"
- An Article by "All3DP" Titled "Klipper vs Marlin: The Differences"