Module Integration

1. Attach joints - shark bite fittings, plumbing fittings, electrical boxes
2. Pre-make assemblies for attachment - complete exposed shower side to loose holder, vent fan with wiring, CSED with breakers and knockout adapter; welded plumbing assemblies; water heater with fittings; water entrance; washer box, etc.
3. Annotate modules - box locations with description, component labels
4. Dingleassemblies - outlet box with coiled up wire of correct length, stapled next to box, flat so it doesn't stick out; cSEd premountes on wall module; plbingbattached spanning entire module ready for interconnect
5. exterior boxes preattached with hole through wall and mount;
6. Trim pre-painted
7. Washer, heater, prewired and plumbed
8. Boxes prewired - with device - so electrical is verified. Test devices - light sockets dangling and tested
9. Cabinets pre-cut. Big kitchen table pre-glued. Sink cutout for clamping.