Seed Eco-Home Design Workbench

Design workbench in FreeCAD that allows for ready creation of modified versions of the Seed Eco-Home. Intended for builders, contractors, architects, and other critters. The simple breakdown is as follows:

1. Foundation: - foundation form plan and staking, footer, rebar pattern, etc for any specific footprint of the Seed Eco-Home. Includes rough plumbing design. Outputs a set of technical drawings with annotations regarding sequence for stringing, squaring, and other important notes.
2. Sill Plate: - generates technical drawings for the sill plate including anchor spacing and specification.
3. 1st Floor Framing: - generates the framing, sheathing, and apertures for the first floor wall modules and garage modules. Generates one technical drawing for each module. Considers the 1300 sf version symmetry 2' filler modules)
4. Top Plate
5. First Floor Ceiling Platform + subfloor
6. 2nd Story Framing - including exterior penetrations
7. 2nd floor top plate
8. 2nd Floor Ceiling platform
9. Roof assembly -tapers, insulation box, sheathing, EPDM
10. PV - pv runners, gravel, gravel lock, PV mounts, PV panels
11. Electrical - adds all electrical boxes based on wall location and code compliance, allowing for the side-to-side shifting of boxes as needed.
12. Wiring - adds all wires based on design rules, optimizing routing
13. Canopy, Deck, Landing designer
14. Vinyl siding Designer
15. Window Designer
16. Trim Designer - exterior
17. Door Designer
18. Beadboard designer
19. Beadboard ceiling designer - garage and 2nd floor
20. Interior trim designer

More:

1. Floor plan generator
2. Elevations generator
3. Rendering automation
4. Site plan generator
5. 3D elevation model generator - via aerial or terrestrial drone surveying
6. Engineering drawings generator - for engineering package
7. Detail generator - for the multitude of architecture details
8. Plumbing generator
9. Water system generator
10. heat pump design generator
11. Power Center Generator - inverter and all other detail
12. Kitchen cabinets generator - multiple cabinets, should break this down further
13. Flooring generator - down to start/end point, tongue and groove detail
14. Bathroom cabinet generator
15. Hardscape generator - integrated with the 3D elevation model generator

Phase 2

1. Mission planning for automated bulldozer - integrated with elevation model generator, ROS, and Ardupilot Rover, based on Beagle Bone AI
2. Mission planner for trenching water, sewer, and power lines