Build Wheel Shafts: Difference between revisions
Jump to navigation
Jump to search
(Created page with "*Cut 1-7/8" shafts to 28" *Cut 6" long collars from 2" pipe *Label collar and shaft, as these are paired up and can't be confused between shafts. *Drill 3/4" hole for wheel plate...") |
(No difference)
|
Revision as of 01:45, 19 June 2011
- Cut 1-7/8" shafts to 28"
- Cut 6" long collars from 2" pipe
- Label collar and shaft, as these are paired up and can't be confused between shafts.
- Drill 3/4" hole for wheel plate mounting through shaft and collar
- Drill through collar and shaft at the same time
- Weld on reinforcing nuts on collars
- End drill 3.5" deep (on a lathe) the 1-3/8" receiver for 6-spline standard PTO shafting