Build Wheel Motor Assemblies and Mount on Tractor: Difference between revisions

Revision as of 21:32, 23 June 2011

Build Motor Interface Plates
- CNC torch motor interface plates
- Grind and clean
- Attach hydraulic motor to interface plate (weld or 4 bolts)
  - If welding, attend to cooling the hydraulic motor
- Weld on 3/4" nut for securing to motor mount plate, on side of hydraulic motor
Build Motor Attachment Plate
- CNC torch motor attachment plates
- Grind and clean (surface needs to be flat, no bumps allowed)
Attach motor interface plates to motor attachment plates
Mount on tractor:
Lift respective wheen off the ground
With shaft collars loose, punch shaft in to approximate correct location, with 6-spline male shaft exposed
MOunt coupler with female 6-spline shaft on hydraulic motor
Insert motor assembly onto 6-spline male shaft

@@ Line 4: / Line 4: @@
 **Attach hydraulic motor to interface plate (weld or 4 bolts)
 ***If welding, attend to cooling the hydraulic motor
-**Weld on 3/4" nut for securing to motor mount plate
+**Weld on 3/4" nut for securing to motor mount plate, on side of hydraulic motor
 *Build Motor Attachment Plate
 **CNC torch motor attachment plates
 **Grind and clean (surface needs to be flat, no bumps allowed)
-**
+*Attach motor interface plates to motor attachment plates
+*Mount on tractor:
+*Lift respective wheen off the ground
+*With shaft collars loose, punch shaft in to approximate correct location, with 6-spline male shaft exposed
+*MOunt coupler with female 6-spline shaft on hydraulic motor
+*Insert motor assembly onto 6-spline male shaft
 [[Category:Fabrication Procedures]]