Build Wheel Motor Assemblies and Mount on Tractor: Difference between revisions
Jump to navigation
Jump to search
(Created page with "*Build Motor Interface Plates **CNC torch motor interface plates **Grind and clean ** Category:Fabrication Procedures") |
No edit summary |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
**CNC torch motor interface plates | **CNC torch motor interface plates | ||
**Grind and clean | **Grind and clean | ||
** | **Attach hydraulic motor to interface plate (weld or 4 bolts) | ||
***If welding, attend to cooling the hydraulic motor | |||
**Weld on 3/4" nut for securing to motor mount plate, on side of hydraulic motor | |||
*Build Motor Attachment Plate | |||
**CNC torch motor attachment plates | |||
**Grind and clean (surface needs to be flat, no bumps allowed) | |||
*Attach motor interface plates to motor attachment plates | |||
*Mount on tractor: | |||
*Lift respective wheen off the ground | |||
*With shaft collars loose, punch shaft in to approximate correct location, with 6-spline male shaft exposed | |||
*MOunt coupler with female 6-spline shaft on hydraulic motor | |||
*Insert motor assembly onto 6-spline male shaft | |||
*Clamp hydraulic motor onto frame member | |||
*Punch shaft in until it's flush with the coupler | |||
*Weld motor mount plate onto frame member | |||
*Tack weld one corner of motor interface plate and motor mount plate together to prevent any slippage while allowing for quick disassembly via a 30 second grind | |||
*Done with one wheel, move onto others | |||
[[Category:Fabrication Procedures]] | [[Category:Fabrication Procedures]] | ||
Latest revision as of 21:35, 23 June 2011
- Build Motor Interface Plates
- CNC torch motor interface plates
- Grind and clean
- Attach hydraulic motor to interface plate (weld or 4 bolts)
- If welding, attend to cooling the hydraulic motor
- Weld on 3/4" nut for securing to motor mount plate, on side of hydraulic motor
- Build Motor Attachment Plate
- CNC torch motor attachment plates
- Grind and clean (surface needs to be flat, no bumps allowed)
- Attach motor interface plates to motor attachment plates
- Mount on tractor:
- Lift respective wheen off the ground
- With shaft collars loose, punch shaft in to approximate correct location, with 6-spline male shaft exposed
- MOunt coupler with female 6-spline shaft on hydraulic motor
- Insert motor assembly onto 6-spline male shaft
- Clamp hydraulic motor onto frame member
- Punch shaft in until it's flush with the coupler
- Weld motor mount plate onto frame member
- Tack weld one corner of motor interface plate and motor mount plate together to prevent any slippage while allowing for quick disassembly via a 30 second grind
- Done with one wheel, move onto others