Cold Saw/V1 Design Files/Shaft Block: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
Line 5: Line 5:
*'''Width: 50.8mm'''
*'''Width: 50.8mm'''


*'''Height: 150mm'''
*'''Height: 100mm'''




Line 12: Line 12:
*'''Shaft Hole Spacing Along Length: Centered'''
*'''Shaft Hole Spacing Along Length: Centered'''


*'''Shaft Hole Spacing Along Height: 115mm'''
*'''Shaft Hole Spacing Along Height: 65mm'''





Revision as of 22:43, 4 June 2012

Shaft Block

  • Length: 76.2mm
  • Width: 50.8mm
  • Height: 100mm


  • Shaft Hole Diameter: 31.8mm
  • Shaft Hole Spacing Along Length: Centered
  • Shaft Hole Spacing Along Height: 65mm


  • Mount Hole Diameter: 10.5mm then M12x1.75 Tap
  • Mount Hole Depth: 50mm
  • Mounting Rectangle: 30mm x 55mm
  • Mount Rectangle Spacing: Centered


  • Height Notes: If the Shaft Block is high, rigidity decreases but the shaft can be placed at a higher point- in which case the blade's arc of travel (between the bottom stop and the closest contact point with the clamping volume) has a lower horizontal difference. In this case, the function of the horizontal difference for different height values of the Shaft Block reveals that the change is low enough to justify higher rigidity over higher centering versatility.
  • 2D Image

ColdSawV1ShaftBlock.jpg

  • 3D CAD STP

File:ColdSawV1ShaftBlock.stp

  • 2D Fabrication Drawing PDF

File:ColdSawV1ShaftBlock.pdf

  • 2D Fabrication Drawing DXF

File:ColdSawV1ShaftBlock.dxf