Cold Saw/V1 Design Files/Shaft Block: Difference between revisions
< Cold Saw | V1 Design Files
Jump to navigation
Jump to search
(Created page with "=Shaft Block= *'''2D Image''' 500px *'''3D CAD STP''' File: ColdSawV1ShaftBlock.stp *'''2D Fabrication Drawing PDF''' [[File: ColdSaw...") |
|||
| (15 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
=Shaft Block= | =Shaft Block= | ||
*'''Length: 76.2mm''' | |||
*'''Width: 50.8mm''' | |||
*'''Height: 150mm''' | |||
*'''Shaft Hole Diameter: 31.8mm''' | |||
*'''Shaft Hole Spacing Along Length: Centered''' | |||
*'''Shaft Hole Spacing Along Height: 65mm''' | |||
*'''Stopper Adjustment Hole: 10.5mm DIA, then M12x1.75 Tap with 20mm DIA 13mm Depth Counterbore''' | |||
*'''Stopper Adjustment Hole Depth: 60mm''' | |||
*Stopper Adjustment Hole Positioning: Corner | |||
*'''Fastening Notes: The shaft block can be welded onto the swivel plate (while a shaft is through their holes for alignment purposes) because precision along the horizontal plane is not important where the cutting angle is designed to change.''' | |||
*'''2D Image''' | *'''2D Image''' | ||
Latest revision as of 22:50, 15 June 2012
Shaft Block
- Length: 76.2mm
- Width: 50.8mm
- Height: 150mm
- Shaft Hole Diameter: 31.8mm
- Shaft Hole Spacing Along Length: Centered
- Shaft Hole Spacing Along Height: 65mm
- Stopper Adjustment Hole: 10.5mm DIA, then M12x1.75 Tap with 20mm DIA 13mm Depth Counterbore
- Stopper Adjustment Hole Depth: 60mm
- Stopper Adjustment Hole Positioning: Corner
- Fastening Notes: The shaft block can be welded onto the swivel plate (while a shaft is through their holes for alignment purposes) because precision along the horizontal plane is not important where the cutting angle is designed to change.
- 2D Image
- 3D CAD STP
- 2D Fabrication Drawing PDF
- 2D Fabrication Drawing DXF