Cold Saw/V1 Design Files/Shaft Block: Difference between revisions
< Cold Saw | V1 Design Files
Jump to navigation
Jump to search
| (5 intermediate revisions by the same user not shown) | |||
| Line 12: | Line 12: | ||
*'''Shaft Hole Spacing Along Length: Centered''' | *'''Shaft Hole Spacing Along Length: Centered''' | ||
*'''Shaft Hole Spacing Along Height: | *'''Shaft Hole Spacing Along Height: 65mm''' | ||
*''' | *'''Stopper Adjustment Hole: 10.5mm DIA, then M12x1.75 Tap with 20mm DIA 13mm Depth Counterbore''' | ||
*''' | *'''Stopper Adjustment Hole Depth: 60mm''' | ||
* | *Stopper Adjustment Hole Positioning: Corner | ||
*'''Fastening Notes: The shaft block can be welded onto the swivel plate (while a shaft is through their holes for alignment purposes) because precision along the horizontal plane is not important where the cutting angle is designed to change.''' | |||
*'''2D Image''' | *'''2D Image''' | ||
Latest revision as of 22:50, 15 June 2012
Shaft Block
- Length: 76.2mm
- Width: 50.8mm
- Height: 150mm
- Shaft Hole Diameter: 31.8mm
- Shaft Hole Spacing Along Length: Centered
- Shaft Hole Spacing Along Height: 65mm
- Stopper Adjustment Hole: 10.5mm DIA, then M12x1.75 Tap with 20mm DIA 13mm Depth Counterbore
- Stopper Adjustment Hole Depth: 60mm
- Stopper Adjustment Hole Positioning: Corner
- Fastening Notes: The shaft block can be welded onto the swivel plate (while a shaft is through their holes for alignment purposes) because precision along the horizontal plane is not important where the cutting angle is designed to change.
- 2D Image
- 3D CAD STP
- 2D Fabrication Drawing PDF
- 2D Fabrication Drawing DXF